Naber 1013123, Corno Piu PRU3, built-in sink stainless steel
Product number:
1013123
Product information "Naber 1013123, Corno Piu PRU3, built-in sink stainless steel"
Description of the
Corno Piu PFU3, stainless steel
With its discreet design, the square built-in/undermounted sink Corno Piu PFU3 is ideal for island solutions. Its look is characterised by a symmetrical rim geometry and small corner radii. The flush-mounted overflow integrated into the top edge matches the purist appearance. The material used is high-quality stainless steel, which is finished with a fine structure using a wet grinding process. This results in an insensitive and easy-care surface that also allows water to run off easily. Thanks to the flat rim, the single bowl sink can be surface-mounted or flush-mounted, depending on requirements. An undermount solution with a recessed look is also possible, in which the layered decor of the worktop is visible. The kitchen sink is available individually or as a set with the matching Mio 3 mixer tap. A flush-mounted basket strainer valve and a drain and overflow set are available as an ideal addition to the equipment.
Inset/undercounter sink. Single bowl. 3½" drain and overflow set with flush-to-floor strainer basket valve. When using the fixing clips supplied, the required installation width per side is increased by approx. 30 mm for the undermount sink.
Flat rim: also suitable for flush installation
- suitable for worktop thicknesses of 10-40 mm (built-in sink) or 20 mm (undermount sink)
- Cut-out dimensions approx. 430 x 430 mm (built-in sink)
- Cut-out dimensions approx. 401 x 401 mm (undermount sink)
Inset/undercounter sink. Single bowl. 3½" drain and overflow set with flush-to-floor strainer basket valve. When using the fixing clips supplied, the required installation width per side is increased by approx. 30 mm for the undermount sink.
Flat rim: also suitable for flush installation
- suitable for worktop thicknesses of 10-40 mm (built-in sink) or 20 mm (undermount sink)
- Cut-out dimensions approx. 430 x 430 mm (built-in sink)
- Cut-out dimensions approx. 401 x 401 mm (undermount sink)
Manufacturer information according to general product safety regulations (GPSR)
Naber GmbH
Enschedestr. 24
48529 Nordhorn
Germany
Login